GRAPHTEC CE7000-60 - 8.2 Perform Automatic Pre Feed When Cut Data is Received

CE7000-UM-251-9370 8-53
8 Electrical Adjustment
(15) Press the ENTER key to draw the cross marks by pen 1 and pen 2 as shown below.
Media feed
direction
Lines plotted by tool 2
Cross mark
plotted by
tool 1
Y
X
+Y -Y
+X
-X
(16) The following menu is displayed after the cross marks plots.
(17) Measure the offset between the tool 1 cross mark and the tool 2 lines.
(18) When it needs to adjust for X direction (feeding direction), press the F3 key to display the following
menu.
Set the X-offset value.
Press the UP or DOWN position key to change the number based on the pen 1 of cross mark.
(19) Press the ENTER key after offset value is input, the following menu is displayed.
(20) When it needs to adjust for Y direction (pen block moving direction), press the F4 key to display the
following menu.
Set the Y-offset value.
Press the UP or DOWN position key to change the number based on the pen 1 cross mark.