CE7000-UM-251-9370 7-41
7 DISASSEMBLY AND REASSEMBLY
(9) Remove the M3L6 binding head screw holding the Y-motor cover, and then detach the Y-motor cover.
Y Motor Cover
M3L6 binding head screw
(10) Mark the position of screws which are holding the X motor as shown in the picture below.
Mark the position of screws which are holding the X motor.
(11) Loosen the three M3L6 binding head screws holding the X-motor to loosen the X drive belt, and then
detach the X drive belt.
(12) Loosen the four M3L4WP set screws holding the X-drive pulley, and then detach the X-drive pulley from
the drive roller shaft.
X drive pulley
M3L4WP set screw
X drive pulley
X drive belt
To Next Page
Loading...
