GRAPHTEC CE7000-60 - Page 122

CE7000-UM-251-9370 7-48
7 DISASSEMBLY AND REASSEMBLY
How to reinstall the Y Flexible cable
(1) Fold the Y relay board side of Y exible cable at same position with the removed Y exible cable.
(2) Move the pen block to the left end.
(3) Fit the Y-exible cable into the Y-rail as shown below. Make a 10 mm slack from the left end of the Y
relay board (Y exible cable bracket).
CE7000-40/60
CE7000-130/130AP/160
Y relay board
Y exible cable bracket
Y exible cable
Y exible cable
10 mm 10 mm
(4) Secure the Y-exible cable onto the exible cable guide of the Y-rail using double-sided adhesive tape.
(5) Reattach the other parts in the reverse order in which they were detached.
(6) Conrm the wiring for Y exible cable (Refer to subsection 7.4.).