CE7000-UM-251-9370 7-50
7 DISASSEMBLY AND REASSEMBLY
(7) Remove the two M3L10 TP screws holding the cam set lever, and then slide it to the right side.
Set lever
M3L10 TP screw
(8) Remove the M3L10 TP screws holding the left cam shaft holder, and then detach the cam shaft holder
from the cam shaft.
Cam shaft holder
M3L10 TP screw
(9) Mark the position of push roller stopper as shown in the picture bellow, and then loosen the screw
holding the push roller stopper.
Mark the position of stopper here.
Stopper screw
(10) Slide the push roller stopper to the left side of notch of Y rail.
Notch of Y rail
Slide the stopper to here.
To Next Page
Loading...
