CE7000-UM-251-9370 7-52
7 DISASSEMBLY AND REASSEMBLY
CE7000-130/130AP/160
How to detach the Push Roller assembly
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Remove the two M4L10 binding head screws holding the cam sensor dog, and then detach it from the
cam shaft.
Cam sensor dog
Cam sensor dog
Cam shaft
M4L10 binding head screw
(3) Remove the two M3L10 TP screws holding the cam set lever, and then slide it to the right side as shown
in the picture below.
Set lever
M3L10 TP screw
(4) Remove the two M3L10 binding head screws holding the right and the left cam shaft holder.
Cam shaft holder
M3L10 binding head screw
To Next Page
Loading...
