CE7000-UM-251-9370 8-43
8 Electrical Adjustment
(5) Press the PAUSE/MENU key to display the following menu.
(6) Press the Right position key to display the following menu.
(7) Press the Down position key until the following menu is displayed.
(8) Press the F3 key to display the following menu.
(9) Press the F1 key, and then the plotter scan the adjustment target sheet, and then it automatically adjust
the front and the rear media sensor position with the registration mark sensor.
(10) The following menu is displayed after adjusted.
Adjusted value is displayed here.
(11) Press the ENTER key to display the following menu.
(12) Turn off the power for the plotter. (When other adjustment is going to perform continuously it does not
need to turn off the power.)
To Next Page
Loading...
