GRAPHTEC CE7000-60 - 9.3 I;F (LAN)

CE7000-UM-251-9370 9-8
9 TROUBLESHOOTING
Symptom Verication item Solution
The horizontal line of
2nd registration mark
could not detect.
Was the sheet media loaded as the
ROLL 1 or ROLL 2?
The media came off from the grid
roller when the 2nd registration marks
are scanning, which does not have
enough margin from the registration
mark and rear edge of media.
Conrm the 2nd registration mark is
printing in the 6 mm inside from the
cutting area.
Load the media by the SHEET, and then
conrm the tool position is possible to
move to at least 6 mm outside from the
horizontal line of 2nd registration mark.
Print the 2nd registration mark at least
60 mm from the rear edge of media.
Was it printing the small size of
registration mark to the long media?
Print the big size of registration mark,
and load the media straightly.
Is there any black printing object near
the registration mark?
Don’t print any object around the
registration marks.
The vertical line of 2nd
registration mark could
not detect.
Is there enough margin from the right
push roller and the vertical line of 2nd
registration mark?
Conrm the 2nd registration mark is
printing in the 6 mm inside from the right
push roller.
Load the media by the SHEET, and then
conrm the tool position is possible to
move to at least 6 mm outside from the
vertical line of 2nd registration mark.
Print the 2nd registration mark at least 6
mm inside from the cutting area if it is not
possible.
The vertical line of 3rd
registration mark could
not detect.
Is there enough margin from the left
push roller and the vertical line of 3rd
registration mark?
Conrm the 3rd registration mark is
printing in the 6 mm inside from the left
push roller.
Load the media by the SHEET, and then
conrm the tool position is possible to
move to at least 6 mm outside from the
vertical line of 3rd registration mark.
Print the 3rd registration mark at least 6
mm inside from the cutting area if it is not
possible.
Was it printing the small size of
registration mark to the long media?
Print the big size of registration mark,
and load the media straightly.
Is there any black printing object near
the registration mark?
Don’t print any object around the
registration marks.