GRAPHTEC CE7000-60 - Chapter 10: Settings Regarding Operation Environment

CE7000-UM-251-9370 9-18
9 TROUBLESHOOTING
Error
code
Error Display Verication item Cause Solution
E02005
Conrm correct
device is selecting
when the windows
driver is using.
The software
conguration
regarding the output
device has been
changed.
Select the correct
device.
When the RS-232C
interface is using,
conrm transport
setting.
The plotter’s interface
conditions have been
changed.
Re-specify the software
application’s interface
conditions.
E02006
Conrm the out put
setting of application
software.
Data is exceeding the
cutting area.
Set correct output
setting.
E02008
Conrm there is
enough media size to
cut this job.
Media end was
detected.
There is not enough
media to cut it.
Load the roll media that
have enough cutting
area.