GRAPHTEC CE7000-60 - Page 228

CE7000-UM-251-9370 25
9 TROUBLESHOOTING
Error
code
Error Display Cause Solution
E04014
The vertical lines of the 3rd or
the 4th registration mark is not
able to detect by tilt of media
loading.
Load the media straightly or print the
large size of registration marks.
The data was output by wrong
direction.
Output the data by correct direction.
The media was skewing while
the 3rd and 4th registration
marks are detecting.
Use a good media which does not
have the skewing problem.
E04015
The horizontal line of the 1st
or 2nd registration mark is not
printed in the scanning area.
Print the vertical line of 1st and 2nd
registration marks that the right side
push roller is possible to put at least
6 mm outside from vertical line of
1st and 2nd registration marks.
And conrm the media is not tilting
when the media is loading to the
plotter.
If it is tilting, the margin from the
right push roller position to the 1st
and 2nd registration marks needs
more.
E04016
The vertical lines of the 1st and
the 2nd registration mark is not
able to detect by tilt of media
loading.
Load the media straightly or print the
large size of registration marks.
The data was output by wrong
direction.
Output the data by correct direction.
The media was skewing while
the 1st and the 2nd registration
marks are detecting.
Use a good media which does not
have the skewing problem.
E04017
It has exceeded detection area
while detecting the registration
mark.
Conrm the media. Conrm the print
position of the registration mark.
E04018
Media set lever was lowered. Reload the media and try again.
E04019
There was cancel operation by
the user.
Redo the process.