CE7000-UM-251-9370 4-5
4 OPER ATIONS
Operation from COND/TEST key
Simple mode
CONDITION screen (1-5): (Simple mode)
The [COND/TEST] key brings up the SETTING screens, where you can change the media type and tool
conditions.
The preset cutting condition is used when the media type is selected.
[COND/TEST] : This will clear the CONDITION screen and return to default screen.
Normal mode
CONDITION screen (1-3) : (Normal mode)
Tool conditions are set in the setting screens displayed by the [CONDITION] key.
Up to 8 CONDITION settings can be saved with different settings in numbers 1 through 8.
COND/TEST: ........ It will clear the CONDITION screen and return to default screen.
To Next Page
Loading...
