FCX2000-UM-251-9370 8-27
8 DISASSEMBLY AND ASSEMBLY
(6) Conrm the X exible cable is tting to the vertical plate of Y bar as shown in the picture below.
The X exible cable will be damaged by the rear
top cover when the X exible cable did not t to the
vertical plate of Y bar as like as this picture.
This part must t to the vertical plate of Y bar
when the X exible cable is installing.
Good
No good
(7) Move the Y bar to the end of right side.
(8) Make the 10 mm slack on the right side of Y exible bracket.
10 mm
To Next Page
Loading...
