FCX2000-UM-251-9370 9-30
9 ELECTRICAL ADJUSTMENTS
The following menu is displayed.
(11) Press the ENTER key to exit the Tool Interval adjustment menu.
When adjusting the Tool Interval
(10) Load a paper that is suitable for plotting.
(11) Mount pens to the Tool 1 and the Tool 2 holder.
Press the F2 key (TEST PATTERN) to draw the adjustment pattern.
The following menu is displayed.
Use the position keys to move the tool carriage (the tip of the tool selected by the current setting) to the
position where you want to draw the test pattern.
Press the ENTER key.
The plotter will start drawing the following test pattern.
Cross mark
plotted by the
tool 2
Cross mark
plotted by the
tool 1
X
Y
-X +X
+Y
-Y
(12) The following menu is displayed.
To Next Page
Loading...
