FCX2000-UM-251-9370 9-31
9 ELECTRICAL ADJUSTMENTS
(13) Measure the offset between the tool 1 cross mark and the tool 2 lines.
(14) Press the F3 key to display the following menu.
(15) Set the X-offset value. Press the UP ARROW key or DOWN ARROW key to change the number based
on the tool 1 cross mark.
(16) Press the ENTER key after the X-offset is adjusted.
The following menu is displayed.
(17) Press the F4 key to display the following menu.
(18) Set the Y-offset value. Press the UP ARROW key or DOWN ARROW key to change the number based
on the tool 1 cross mark.
(19) Press the ENTER key after the Y-offset is adjusted.
The following menu is displayed.
(20) Record the adjusted values to the factory adjustment values label when the adjustment values are
changed.
(21) Press the ENTER key to exit the Tool Interval adjustment menu.
To Next Page
Loading...
