FCX2000-UM-251-9370 2-21
2 Setup procedure
(7) Cut the rubber cap (C-30-SG-30A-EP-UL) as shown in the picture below by using knife.
Cut the rubber cap on a cross.
Rubber Cap
(8) Install the rubber cap (C-30-SG-30A-EP-UL) to the FRAME_ANGLE>_P.
FRAME_ANGLE_P
Rubber Cap
(9) Disconnect all cable from the main board to replace the control box.
(10) Release the X exible cable and the X home sensor cable from the cable tie.
And then disconnect the X exible cable and the X home sensor cable from the main board.
X exible cable
X home sensor cable
Disconnect the X exible cable from this connector.
Release this cable tie.
Disconnect the X home sensor cable
from this connector (J9).
To Next Page
Loading...
