FCX2000-UM-251-9370 2-22
2 Setup procedure
(11) Disconnect the X motor cables from the main board (J11.J17).
And then remove the cable core tie from the control box.
Disconnect the X motor cables from these
connectors (J11, J17).
Remove the cable core
tie from the control box.
Pinch the bottom of cable core tie by using
the needle-nose pliers from bottom of control
box, and then remove the cable core tie from
the control box.
(12) Disconnect the control panel cable from the main board.
And then remove the control panel cable tie from the main board.
Control panel cable tie
Control panel cable
(13) Disconnect the Emergency Stop Switch cable from the main board (J10).
And then remove all cable ties of the Emergency Stop Switch cable from the control box.
Disconnect the Emergency Stop
Switch cable from the main
board (J10).
Remove the cable ties from the control box.
(14) Remove the two M4L8 binding head screws holding the X exible cable cover, and then detach it.
And then Remove the two M4L8 binding head screws holding the IF side of control box.
X exible cable cover
M4L8 binding head screw
IF side of control box
M4L8 binding head screw
To Next Page
Loading...
