GreenWorks CU800 - Page 159

MALFUNCTION INSPECTION CU800 Service Manual
152
5.4.4 Wheel and Tire Specifications
Wheel hub Dimension
Tire Dimension
Tire Pressure
(Kpa/psi)
Front Wheel
12×6(min)
25×8-12(min)
103 /15
14×7(max)
26×9 -14(max)
Rear Wheel
12×8(min)
25×10-12(min)
124/18
14×9(max)
26×11-14(max)
• Since wheels and tires are crucial to the vehicle operation, inspection for tire pressure and
profile depth is necessary.
• To ensure maximum security and longer life expectancy of the wheel, please periodically
inspect the tire pressure and profile depth. Insufficient tire pressure can result in not only
intensified wearing of the tire but also instability during the course of operating the vehicle (such
as hard turning). Excessive tire pressure can also reduce the friction force between the tire and
ground, causing spinning or loss of control. Therefore, please ensure the tire pressure strictly
complies with figures shown in the chart above.
• Before operating the vehicle each time, please check if profile depth of the tire is over worn,
which might result in spinning, instability, losing of control and other potential security risk of the
vehicle.