GUDEL FlexxPump4 N - Decommissioning Steps

Room
Store the product in a dry location. For information on the required space
and the floor capacity, refer to the layout. Use a covering to protect the
product against dust and dirt.
Temperature
The ambient temperature has to be between -10 and +40 °C. Make sure that
the product is not subjected to great temperature fluctuations.
Air humidity
The air humidity has to be below 75 %.
9.3 Decommissioning
9.3.1 Shutdown
Do not empty the lubrication lines and the gearbox when shutting down the
product.
To shut down the product, proceed as follows:
1 Switch off lubrication system
2 Remove lubrication cartridge
3 Remove connecting cable
4 Disconnect the lubrication lines from the hydraulic outputs
The product has been shut down
9.3.2 Cleaning, rust-proofing
Clean away any dirt and dust from the product. Clean the product thor-
oughly. Dispose of any cloths soaked in oil or grease in an environmentally
friendly manner. Ü2139
Apply corrosion protection to all bright parts.
Decommissioning, storage OPERATING MANUAL FlexxPump4N Lubrication System
3422906891_v1.0_EN-US
134