GW Instek PEL-3000 Series - Page 139

FUNCTION MENU
137
Description
Fast Sequence configuration is split into Timing
Edit configuration and Data Edit configuration.
Timing Edit configuration is used to configure all
the settings that are common to all the steps of the
fast sequence. This includes settings such as the
mode, range, loops and time base.
Data Edit configuration is used to create the actual
steps used in each sequence.
See below for a description of each.
Timing Edit
Overview
A Fast Sequence contains the following timing
settings for each sequence:
Setting
Setting Range
Description
Memo
12 characters
A user-created note for the
currently selected sequence.
Mode
CC, CR
Operating mode for the
sequence.
Range
ILVL
Low I range, low V range
IMVL
Middle I range, low V range
IHVL
High I range, low V range
ILVH
Low I range, high V range
IMVH
Middle I range, high V range
IHVH
High I range, high V range
Loop
Infinity, 01 - 9999
Sets the amount of times to loop
the selected sequence.
Last Load
OFF, ON
Set the load condition after the
end of the sequence.
Last
0.000000
The load setting for when Last
Load is set to ON.