GW Instek PEL-3000 Series - Page 140

PEL-3000(H) User Manual
138
RPTSTEP
0001 - 1000
Last step number (0001-1000)
per loop
Time Base
0.025 - 600ms
Sets the step execution time.
Data Edit
Overview
Each step in a fast sequence contains the following
setting parameters:
Setting
Setting Range
Description
Step
0001 - 1000
Selects/displays the current
step in the sequence.
 The number of available
steps is dependent on the
number of steps added
using the Ins. Point[F1]
functions.
 A minimum of 3 steps.
Value
The current or resistance setting
for the selected operating mode.
TRIG OUT
ON, OFF
When TRIG OUT is set to ON, a
trigger signal is output from the
TRIG OUT BNC terminal at the
start of the step. See page 185
for details.
Time
amplitude
TRIG OUT = ON
TRIG OUT
Start of step
FILL Overview
The FILL function is used to evenly step up the
current or resistance value settings from a starting
step to a finishing step.