GW Instek PEL-3000 Series - Page 149

FUNCTION MENU
147
Trig Voltage(Trig_V)
Sets the trigger to a level
needed to see when the
power supply OCP has
been triggered.
When the power supply
OCP has been triggered, its
voltage output will reset.
The voltage trigger level is
used to test to see if the
voltage output has been
reset.
Note
This mode can only be used under CC mode.
Panel operation
1. Press
FUNC
> OCP[F4].
OCP
ON
Save
OCP
RS232
01/Oct/2018
Previos
Menu
OCP.No:
OCP Function
Range: High
01
Start C:
End C:
Step C:
0.00000
0.00001
0.00001
StepT: 0.10
Delay:
Trig V
last C
0.00
1.00
0.00001
Select Channel
2. Select OCP. No: and select a test setup memory.
OCP. No:
1 ~ 12
3. Set the following parameters for the selected
test setup above:
 Range
 Start C
 End C
 Step_C