GW Instek PEL-3000 Series - Page 156

PEL-3000(H) User Manual
154
 Start W
 End W
 Step W
 Step T
 Delay
 Trig V
 Last W
3. Press the Save[F3] to save the selected test
setup.
Start OPP
4. Press OPP[F1] to turn the OPP function on if it
is off.
5. The OPP function can be started by turning the
load on by pressing
Shift Load
On/
Off
.
 The test watt will increase from the Start W
value to the End W value in steps according to
the Step W value, until the test has finished.
 The test will start running when the power
supply voltage is greater than the Trig V
voltage.
Example: OPP
Function running
Exit
OPPUSB
01/Oct/2018
OPP Test
4.88
V
4.142
A
W
50.61
Fetch Watt: Fetch Volt:
10.03 4.91
0.00 4.92
Running.
10.03
0:00:01