GW Instek PEL-3000 Series - Page 155

FUNCTION MENU
153
Trig Voltage(Trig V)
Sets the trigger to a level
needed to see when the
power supply OPP has
been triggered.
When the power supply
OPP has been triggered, its
voltage output will reset.
The voltage trigger level is
used to test to see if the
voltage output has been
reset.
Last Watt(Last W)
Sets the final watt value
after OPP has been tripped.
This is the steady-state watt
draw after the OPP has
been tripped.
Panel operation
1. Press
FUNC
> Next Manu[F5]. > OPP[F1].
OPP
ON
OPP
USB
01/Oct/2018
Previos
Menu
OPP Function
Range: Low
Start W:
End W:
Step W:
0.0000
0.0001
0.0001
StepT: 0.10
Delay:
Trig V:
last W:
0.00
2.50
0.0000
NO.:
01
Memo: No Memo
2. Set the following parameters for the selected
test setup above:
 OPP No.
 Memo
 Range