1-3
To do… Use the command… Remarks
Set the timeout time for the
user interface
idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a
user interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a
user interface is terminated if
no operation is performed in the
user interface within 10
minutes.
You can use the idle-timeout 0
command to disable the
timeout function.
Set the maximum number of
lines the screen can contain
screen-length screen-length
Optional
By default, the screen can
contain up to 24 lines.
You can use the screen-length
0 command to disable the
function to display information
in pages.
Make terminal services
available
shell
Optional
By default, terminal services
are available in all user
interfaces.
Set the display type of a
terminal
terminal type { ansi | vt100 }
Optional
By default, the terminal display
type is ANSI. The device must
use the same type of display as
the terminal. If the terminal
uses VT 100, the device should
also use VT 100.
Display the information about
the current user interface/all
user interfaces
display users [ all ]
You can execute this command
in any view.
Display the physical attributes
and configuration of the
current/a specified user
interface
display user-interface [ type
number | number ] [ summary ]
You can execute this command
in any view.
To Next Page
Loading...
Need help?
General