27
{ Disabling inconsistent PVID protection
{ Configuring protection features
{ Enabling the device to log events of detecting or receiving TC BPDUs
{ Disabling the device from reactivating edge ports shut down by BPDU guard
{ Enabling BPDU transparent transmission on a port
{ Enabling SNMP notifications for new-root election and topology change events
MSTP tasks at a glance
Configuring the root bridge
To configure the root bridge in MSTP mode, perform the following tasks:
1. Setting the spanning tree mode
Set the span
ning tree mode to MSTP.
2. Configuring an MST region
3. (Optional.) Configuring the root bridge or a secondary root bridge
4. (Optional.) Configuring the device priority
5. (Option
al.) Configuring parameters that affects MSTP topology convergence
{ Configuring the maximum hops of an MST region
{ Configuring the network diameter of a switched network
{ Setting spanning tree timers
{ Setting the timeout factor
{ Configuring the BPDU transmission rate
{ Configuring edge ports
{ Configuring the port link type
6. (Optional.) Configuring the mode a port uses to recognize and send MSTP frames
7. (Optional.) Enabling outputting port state transition information
8. Enabling the spanning tree feature
9. (Option
al.) Configuring advanced spanning tree features
{ Performing mCheck
{ Configuring Digest Snooping
{ Configuring No Agreement Check
{ Configuring TC Snooping
{ Configuring protection features
{ Disabling the device from reactivating edge ports shut down by BPDU guard
{ Enabling BPDU transparent transmission on a port
{ Enabling SNMP notifications for new-root election and topology change events
Configuring the leaf nodes
To configure the leaf nodes in MSTP mode, perform the following tasks:
1. Setting the spanning tree mode
Set the span
ning tree mode to MSTP.
2. Configuring an MST region
3. (Optional.) Configuring the device priority
4. (Option
al.) Configuring parameters that affects MSTP topology convergence
{ Setting the timeout factor
To Next Page
Loading...
Need help?
General