H3C S6850 Series Configuration Guide

9
port trunk permit vlan { vlan-id-list | all }
By default, a trunk port permits only VLAN 1.
5. (Optional.) Set the PVID for the trunk port.
port trunk pvid vlan vlan-id
The default setting is VLAN 1.
Assigning a hybrid port to a VLAN
About assigning a hybrid port to a VLAN
A hybrid port supports multiple VLANs. You can assign it to the specified VLANs in interface view.
Make sure the VLANs have been created.
Restrictions and guidelines
To change the link type of a port from trunk to hybrid, set the link type to access first.
To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the PVID
by using the
port hybrid vlan command.
Procedure
1. Enter system view.
system-view
2. Enter interface view.
{ Enter Layer 2 Ethernet interface view.
interface
interface-type interface-number
{ Enter Layer 2 aggregate interface view.
interface bridge-aggregation interface-number
3. Set the port link type to hybrid.
port link-type hybrid
By default, all ports are access ports.
4. Assign the hybrid port to the specified VLANs.
port hybrid vlan vlan-id-list { tagged | untagged }
By default, the hybrid port is an untagged member of the VLAN to which the port belongs when
its link type is
access.
5. (Optional.) Set the PVID for the hybrid port.
port hybrid pvid vlan vlan-id
By default, the PVID of a hybrid port is the ID of the VLAN to which the port belongs when its link
type is
access.
Configuring MAC-based VLANs
Restrictions and guidelines for MAC-based VLANs
• MAC-based VLANs are available only on hybrid ports.
• Do not configure a VLAN as both a super VLAN and a MAC-based VLAN.
• The MAC-based VLAN feature is mainly configured on downlink ports of user access devices.
Do not use this feature with link aggregation.

H3C S6850 Series Specifications

General

Brand	H3C
Model	S6850 Series
Category	Switch
Language	English