17
7. Assign the aggregate interface to an S-MLAG group.
port s-mlag group group-id
By default, an aggregate interface is not assigned to any S-MLAG group.
Configuring an aggregate interface
Most settings that can be made on Layer 2 or Layer 3 Ethernet interfaces can also be made on Layer
2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface
About the aggregate interface description
You can configure the description of an aggregate interface for administration purposes, for example,
describing the purpose of the interface.
Procedure
1. Enter system view.
system-view
2. Enter aggregate interface view.
{ Enter Layer 2 aggregate interface view.
interface bridge-aggregation interface-number
{ Enter Layer 3 aggregate interface view.
interface route-aggregation interface-number
{ Enter Layer 3 aggregate subinterface view.
interface route-aggregation interface-number.subnumber }
3. Configure the interface description.
description text
By default, the description of an interface is interface-name Interface.
Setting the MAC address for an aggregate interface
About the aggregate interface MAC address
Typically, all aggregate interfaces on a device use the same MAC address, and aggregate interfaces
on different devices use different MAC addresses. However, you must set different MAC addresses
for aggregate interfaces on a device in some situations.
Procedure
1. Enter system view.
system-view
2. Enter aggregate interface view.
{ Enter Layer 3 aggregate interface view.
interface route-aggregation interface-number
{ Enter Layer 3 aggregate subinterface view.
interface route-aggregation interface-number.subnumber
3. Set the MAC address for the aggregate interface.
mac-address mac-address
To Next Page
Loading...
Need help?
General