H3C S6850 Series Configuration Guide

25
interface interface-type interface-number
3. Configure CRC error packet alarm parameters for the interface.
port ifmonitor crc-error [ ratio ] high-threshold high-value
low-threshold low-value interval interval [ shutdown ]
By default, the upper threshold is 1000, the lower threshold is 100, and the statistics collection
and comparison interval is 10 seconds for CRC error packets.
Configuring input error packet alarm parameters
1. Enter system view.
system-view
2. Enter Ethernet interface view.
interface interface-type interface-number
3. Configure input error packet alarm parameters for the interface.
port ifmonitor input-error high-threshold high-value low-threshold
low-value interval interval [ shutdown ]
By default, the upper threshold is 1000, the lower threshold is 100, and the statistics collection
and comparison interval is 10 seconds for input error packets.
Configuring output error packet alarm parameters
1. Enter system view.
system-view
2. Enter Ethernet interface view.
interface interface-type interface-number
3. Configure output error packet alarm parameters.
port ifmonitor output-error high-threshold high-value low-threshold
low-value interval interval [ shutdown ]
By default, the upper threshold is 1000, the lower threshold is 100, and the statistics collection
and comparison interval is 10 seconds for output error packets.
Restoring the default settings for an interface
Restrictions and guidelines
CAUTION:
This feature might interrupt ongoing network services. Make sure you are fully aware of the impacts
of this feature when you use it in a live network.
This feature might fail to restore the default settings for some commands because of command
dependencies or system restrictions. You can use the
display this command in interface view to
check for these commands and perform their
undo forms or follow the command reference to
restore their default settings. If your restoration attempt still fails, follow the error message to resolve
the problem.
Procedure
1. Enter system view.
system-view
2. Enter Ethernet interface view or Ethernet subinterface view.
interface interface-type { interface-number |
interface-number.subnumber
}
3. Restore the default settings for the interface.

H3C S6850 Series Specifications

General

Brand	H3C
Model	S6850 Series
Category	Switch
Language	English