26
link-aggregation load-sharing ignore { destination-ip |
destination-mac | destination-port | ethernet-type | ingress-port |
ip-protocol | mpls-label1 | mpls-label2 | mpls-label3 | source-ip |
source-mac | source-port | vlan-id } *
By default, no ignored packet fields are specified for default link-aggregation load sharing.
Enabling local-first load sharing for link aggregation
About local-first load sharing for link aggregation
Use local-first load sharing in a multidevice link aggregation scenario to distribute traffic preferentially
across member ports on the ingress slot.
When you aggregate ports on different member devices in an IRF fabric, you can use local-first load
sharing to reduce traffic on IRF links, as shown in Figure 6. For
more information about IRF, see
Virtual Technologies Configuration Guide.
Figure 6 Load sharing for multidevice link aggregation in an IRF fabric
Enabling local-first load sharing for link aggregation globally
1. Enter system view.
system-view
2. Enable local-first load sharing for link aggregation globally.
link-aggregation load-sharing mode local-first
By default, local-first load sharing is enabled globally.
Any Selected ports on the
ingress device?
Local-first load sharing
mechanism enabled?
Yes No
Yes
No
The egress port for a traffic flow is an
aggregate interface that has Selected
ports on different IRF member devices
Packets are load-shared only
across the Selected ports on the
ingress device
Packets are load-shared across
all Selected ports
To Next Page
Loading...
Need help?
General