H3C S6850 Series Configuration Guide

13
interface interface-type interface-number
{ Enter Layer 3 aggregate interface/subinterface view.
interface route-aggregation { interface-number |
interface-number.subnumber }
{ Enter IRF physical interface view.
interface interface-type interface-number
3. Disable the static source check feature.
undo mac-address static source-check enable
By default, the static source check feature is enabled.
Enabling SNMP notifications for the MAC address
table
About SNMP notifications for the MAC address table
To report critical MAC address move events to an NMS, enable SNMP notifications for the MAC
address table. For MAC address move event notifications to be sent correctly, you must also
configure SNMP on the device.
When SNMP notifications are disabled for the MAC address table, the device sends the generated
logs to the information center. To display the logs, configure the log destination and output rule
configuration in the information center.
For more information about SNMP and information center configuration, see the network
management and monitoring configuration guide for the device.
Procedure
1. Enter system view.
system-view
2. Enable SNMP notifications for the MAC address table.
snmp-agent trap enable mac-address [ mac-move ]
By default, SNMP notifications are enabled for the MAC address table.
When SNMP notifications are disabled for the MAC address table, syslog messages are sent to
notify important events on the MAC address table module.
Display and maintenance commands for MAC
address table
Execute display commands in any view.
Task Command
Display MAC address table
information.
display mac-address
[ mac
-
address [
vlan
vlan-id ] | [ [
dynamic
|
static
] [
interface
interface-type interface-number
] |
blackhole
|
multiport
] [
vlan
vlan-id ]
[
count
] ]
Display the aging timer for dynamic
MAC address entries.
display mac-address aging-time

H3C S6850 Series Specifications

General

Brand	H3C
Model	S6850 Series
Category	Switch
Language	English