Page 106
Remedy: To ensure that you will be able to save all modified files, you should save or
close any files you no longer need open right away. Save any smaller files
first, which will free up some space, then larger files.
"Page memory almost full"
Cause: While you are working within the Editor, the Braille System constantly
checks how many pages can still be administered. The Editor can manage
a total of 3072 pages. If only 10 more pages can be created, you will be
notified with this message.
Remedy: Close any files not currently needed to make room for more pages.
"Switching to read-only mode"
Cause: You are attempting to open a file. The Editor determines that with the
amount of memory left, the file can be opened, but not edited.
Remedy: Close and save any files not currently needed.
"File X not found"
Cause: You are attempting to open a file in the Editor in read-only mode, but the
file was not found. X is the file name you entered.
Remedy: Try to reenter the file name. It is important to note that the file name must
be entered with exactly the same spelling under which it is stored on the
Braille System. If the result is again negative, you can suspend the Editor
and open the file from the file list.
"Writing X aborted"
Cause: While saving a file, you have pressed the [ESC] key. The saving process
has therefore been canceled.
"Not enough space on disk"
Cause: You are attempting to cut, copy, or save a text block to a new file. While
writing the block, the Editor determines that there is not enough memory
available for this operation.
"X in use, please close it first"
Cause: You have opened file X within the Editor, and are currently working on a
different file. You are attempting to write to file X, or to read data from file X.
For example, you might have opened the clipboard within the Editor in
order to make changes in it before pasting its contents to a file. If you try to
cut or copy any other text block at this point, without first closing the
clipboard, the Editor cannot execute that function and will instead notify you
with this message.
"Cannot open file X"
Cause: You are attempting to open the Editor's swapfile. This is not possible,
because this file contains the portions of text that have been edited, and it
is only accessible to the Editor itself. X is the name of the swapfile.
"Copy to X failed"
"Cut to X failed"
"Paste from X failed"
Cause: You are attempting to execute block operations, but the file system cannot
provide the memory needed. X is the clipboard's file name.
"No space to open another file"
Cause: You tried to open a new file. The editor is not able to do this. The editor can
open only 5 files at one time.
Remedy: Close files, you do not need at the moment.
"End of text" Cause: You are at the end of a file and are attempting to call up ASCII
representation.
To Next Page
Loading...
Need help?
General