Harris DiamondCD Series - Section 10 Replacing AC Input Fuses

C-18 888-2463-001 3/6/08
WARNING: Disconnect primary power prior to servicing.
Diamond Series™
Appendix C Pioneer Power Supply
PM33215F-8 Instructional Manual, Rev 3, 4/23/2007
16
Section 10 Replacing AC Input Fuses
Step 1: To Remove the Top cover, follow the instructions below.
Top Cover
7
6
5
4
23
1
Remove the six screws on one side at the marked locations. The screws marked 1 and
6 are covered by the Warranty labels. Remove these screws w/o removing the labels.
Remove screw 7. This will allow pulling the front panel out in step 4.
Note screw size and locations
Step 2: Remove screws on other side as indicated
Top Cover
8
7
6
5
4
23
1
Remove the seven screws on the other side at the marked locations. The screws marked 1
and 7 are covered by the Warranty labels. Remove these screws w/o removing the labels.
Remove screw 8. This will allow pulling the front panel out in step 4.
Note screw size and locations