July 2010 11 – 127
Saving the
LOGIC DIAGRAM
recording
After having recorded a LOGIC DIAGRAM, you can save it on the hard disk of the control:
8 Press this soft key.
8 Confirm with the ENT key.
--> The logic diagram is saved under PLC:\TRCSAVE.A.
Calling the
LOGIC DIAGRAM
recording
A saved LOGIC DIAGRAM recording can be called again:
8 Press this soft key.
8 Confirm with the ENT key.
--> The contents of the LOGIC DIAGRAM diagram is saved under PLC:\TRCSAVE.A.
Further possibilities
with the integrated
oscilloscope
Also the integrated oscilloscope offers the possibility to record inputs, outputs, markers and
the control signals of timer and counter! It is also possible to record bytes, words and double
words with 6 channels available.
See “Integrated Oscilloscope” on page 10 – 99!
To Next Page
Loading...
