8 – 82 HEIDENHAIN Service Manual iTNC 530
8.2 Calling the Log
8 Enter the code number LOGBOOK. --> Siehe “Input of Code Numbers” on page 3 – 18
The following window appears:
8 If you wish, you can change the path and the file name here.
Default: TNC:\LOGBOOK.A.
8 You can also define the starting point and the end point for reading out the log.
8 Then start reading out the log by pressing the EXECUTE soft key.
An ASCII file with the log entries is generated and displayed on the screen!
Ensure correct spelling when making any changes in the log window.
The log can be read out directly from the PC/laptop with the software tool TNCremoNT from
HEIDENHAIN. The code number LOGBOOK has not to be entered on the control.
The local time on the control and the PC/laptop should be identical!
To Next Page
Loading...
