HEIDENHAIN ITNC 530 - Corrective Action

20 – 354 HEIDENHAIN Service Manual iTNC 530
20.2.7 Corrective action
Control If you have found that the analog interface on the MC is defective:
 Replace the MC. --> See ”Exchange of HEIDENHAIN Components” on page 28 – 523.
Drive
components
If you have found that the analog servo amplifier or the motor is defective:
 Replace the drive component. --> Ask the respective manufacturer!
Mechanics If you have found that the fault is due to the mechancis of the machine tool:
 Replace mechanical components. --> Ask your machine tool builder.