14 – 210 HEIDENHAIN Service Manual iTNC 530
14.3 Proceeding up to NC Software 34049x-01 (Single-Processor Version)
8 Call the machine parameter list with the corresponding code number.
8 Now press the MOD key.
8 Press the UPDATE DATA soft key.
8 Press the BIN --> ASC softkey to convert the files on the hard disk from binary to
ASCII format.
8 Press the soft key NCVER --> All NC software versions on the control now appear in the
following selection window.
8 The currently used software version is distinguished by an asterisk in the first column Sel.
Place the cursor to the marked NC software version!
8 Press the SELECT soft key.
Equivalent file name extensions in binary and ASCII format
.H .H% .I .I% .T .T%
.TCH .TC% .D .D% .P .P%
.PNT .PN% .COM .CO% .CMA .CM%
You may only activate the NC software currently used by the machine!
A change to another NC software version is not described in this Service Manual and must
only be made in agreement with the machine manufacturer.
To Next Page
Loading...
