HEIDENHAIN ITNC 530 - Setting the Program Manager

12 – 162 HEIDENHAIN Service Manual iTNC 530
12.6 Setting the Program Manager
The iTNC 530 offers several possibilities for setting the program manager.
How to change the settings:
8 Select the Programming and Editing operating mode.
(The program manager should not be open).
8 Call the code number window.
8 Call the interface setups. Here you can also find the setting for the program
manager.
The following window appears:
8 Place the cursor in the line PGM MGT.
8 Press the GOTO key. --> A selection window opens.
8 Select a setting and confirm with the ENT key.
8 Leave the setting page with the END soft key or the END key.
PGM MGT setting Advantages, e.g.
Enhanced 2 Compl ete mouse f unction, wi ndow sizes adjustable
Enhanced 1 Frequently used setting
Standard Display as with old HEIDENHAIN controls
Note
Descriptions in this iTNC 530 Service Manual use the program manager with the setting
Enhanced 1.