HEIDENHAIN ITNC 530 - Activation and Operation

9 – 90 HEIDENHAIN Service Manual iTNC 530
9.2 Activation and Operation
Calling the
drive diagnosis
Up to and including NC software version 34049x-03:
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Press the MOD key.
8 Press the DIAGNOSIS soft key.
8 Press the DRIVE DIAGNOSIS soft key. --> A new window opens:
Note
Pressing the MOD key while the program manager is open calls the interface settings.