HEIDENHAIN ITNC 530 - Overview of Log Entries

July 2010 8 – 83
8.3 Overview of Log Entries
Entry Description
RESET Restart the control.
ERR Error messages
 P --> PLC error message with line number in the PLC error text file
 N --> NC error message with number
 Power fail interrupt ! --> Control was switched off by a
POWERFAIL
 Result of the file system test:
If the control is not properly shut down, the file system is checked
during the next startup and the result is entered in the log.
--> Search in the log for "dosfsck"
INFO MAIN ERRCLEARED Confirmation of an error message
INFO MAIN ERR_RECURED Error message entered several times
KEY Key strokes
INFO MAIN SOFTKEY Path with associated image file of a pressed soft key
STIB
a
ON "Control-in-operation" on
OFF "Control-in-operation" off
BLINK "Control-in-operation" blinking
INFO MAIN START Type of control, NC software and valid "Feature Content Level" (FCL)
INFO MAIN FILE DEL Faulty files on the hard disk, to be erased during booting
INFO MAIN HDD Designation of the hard disk
INFO MAIN DSP Id. Nr. of the active controller software
INFO MAIN CYCLES Test results for fixed cycles and touch probe cycles
INFO MAIN KEYSOURCE Source of the keystrokes
 KEYBOARD
 PLC
 PLCNCSTART
 HANDWHEEL
 LSV2
INFO MAIN KINEMATIC Listing of the definition tables with collision bodies that are monitored
for collision with option #40, DCM.
INFO MAIN PGM Started NC program or NC macro
INFO MAIN LINE Line number of the running NC program or NC macro
a. STIB (control-in-operation symbol) = "* " in the screen display
Entry Description
INFO MAIN PGMEND Information about the program end in program run
(you can find byte 0 and 1 in the second line from the left)
Byte 0/1 00 01 Emergency stop
00 02 Positioning error
00 03 Programmed stop
00 04 Block end in single block mode
00 05 Geometry error
00 06 END PGM, M02
00 07 TNC STOP button
00 08 Data transmission error
(RS-422/RS-232)
In addition, when an NC program is stopped by an error message, the
following information is entered:
NC program, line number, actual position, datum, datum shifts, tool
number