HEIDENHAIN ITNC 530 - List of Machine Parameters

30 – 580 HEIDENHAIN Service Manual iTNC 530
30.4 List of Machine Parameters
(excerpt from the Technical Manual of iTNC 530 of May 2009)
30.4.1 Encoders and machines
MP Function and input SW version
and
behavior
MP10 Active axes
Format: %xxxxxxxxxxxxxx
Input: Bits 0 to 13 represent axes 1 to 14
0: Axis not active
1: Axis active
PLC
RUN
MP12 Axis-specific demo operation for NC axes
Format: %xxxxxxxxxxxxxx
Input: Bits 0 to 13 represent axes 1 to 14
0: Demo operation not active
1: Demo operation active
PLC
RUN
MP20 Monitoring functions for the axes
Format: %xxxxxxxxxxxxxx
Input: Bits 0 to 13 represent axes 1 to 14
0: Monitoring not active
1: Monitoring active
PLC
RUN
MP20.0 Absolute position of the distance-coded reference marks
MP20.1 Amplitude of encoder signals
MP20.2 Edge separation of encoder signals
MP21 Monitoring functions for the spindle
Format: %xx
Input:
Bit 0 – Spindle 1
0: Monitoring not active
1: Monitoring active
Bit 1 – Spindle 2
0: Monitoring not active
1: Monitoring active
PLC
RUN
MP21.0 Absolute position of the distance-coded reference marks
MP21.1 Amplitude of encoder signals
MP21.2 Edge separation of encoder signals
MP100 Designation of axes
Format: -wvucbazyxWVUCBAZYX
Input: Characters 1 to 9 from the right represent axes 1 to 9
PLC
RUN
MP100.0 Traverse range 1
MP100.1 Traverse range 2
MP100.2 Traverse range 3
MP110.x Assignment of position encoder inputs to the axes
Input: 0: No position encoder input
1 to 6: Position encoder inputs X1 to X6
35 to 38: Position encoder inputs X35 to X38
201 to 214: Position encoder inputs X201 to X214
RESET