14 – 212 HEIDENHAIN Service Manual iTNC 530
14.4 Proceeding as of NC Software 34049x-02 (Single-Processor Version)
8 Call the machine parameter list with the corresponding code number.
8 Now press the MOD key.
8 Press the UPDATE DATA soft key.
8 Press the SELECT soft key. --> All NC software versions and service packs on the control now
appear in the following selection window.
8 The currently used software version is distinguished by a asterisk in the first column Sel.
Place the cursor to the marked NC software version!
8 Press the SELECT soft key.
8 Confirm your selection with the YES soft key.
Do not confuse NC software versions and service packs!
NC software versions do not have the extension SP (e.g., 340490.004).
The preceding NC software version helps to assign the service packs. Then follows SP with
the number of the pack (e.g., 340490.004 SP6).
You may only activate the NC software currently used by the machine!
A change to another NC software version is not described in this Service Manual and must
only be made in agreement with the machine manufacturer.
To Next Page
Loading...
