HEIDENHAIN ITNC 530 - Execution up to NC Software 34049 x-01 (Single and Dual Processor Version)

July 2010 15 – 221
15.3 Execution up to NC Software 34049x-01 (Single and Dual Processor Version)
Unzipping the
ZIP File
The provided ZIP file, e.g., 34049001sp2.zip) has still to be unzipped on a data medium
(PC/laptop)!
A folder with the number of the NC software (e.g., 34049001) is created.
It includes the service pack in compressed format (e.g., 340490_001_SP2.zip).
Access to the
service pack files
via the customer
network
If the control is connected to the company network and the service pack files were filed on a
released folder of the network, you have access to these data. --> If necessary, ask the system
administrator.
Otherwise, you may also transfer the service pack from your service laptop to the control.
Transferring files
service packs from
the laptop to the
control
8 Reboot the control; the Power interrupted message is displayed.
8 Establish the connection between the laptop and the control. --> See “Connection Setup” on
page 13 – 172.
8 Select the PLC partition of the iTNC 530 and create a new folder
(e.g., PLC:\servicepacks).
8 Open the folder.
8 Transfer the folder with the service pack from your laptop to the iTNC 530.
8 Separate the connection to TNCremoNT.
Loading the
service pack
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Press the MOD key.
8 Press the SP --> ITNC soft key.
A pop-up window is opened.
8 In the upper part of the window, set the cursor to the folder that contains the zip file of the
service pack.
8 Press the ENT key. --> All ZIP files of available service packs are shown in the lower part of
the window.
8 Press the FILES soft key . --> The cursor changes to the lower part of the window.
Note
Pressing the MOD key while the program manager is open calls the interface settings.
Note
With the +/- key you may open and close the directory trees.