3 – 18 HEIDENHAIN Service Manual iTNC 530
3.3 Input of Code Numbers
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Call the code number window.
8 Enter the code number and press ENT to confirm.
When you have finished your work, reset all previously entered code numbers:
8 Enter the code number 0 and press ENT to confirm.
8 Press END to exit the code-number page.
Pressing the MOD key while the program manager is open calls the interface settings.
When certain code numbers are entered, new soft keys are displayed, MP EDIT,
PLC EDIT, OSCI.
With these soft keys you can also change to the corresponding areas without having to
enter the code number again.
All key codes are reset when the control is restarted.
To Next Page
Loading...
