July 2010 11 – 139
Strobe signals from the PLC to the NC
Acknowledgment of NC strobe signals
Strobe signals from the PLC to the NC
M 4053 Probing process has been completed or canceled NC NC
M 4054 Battery voltage too low (battery warning at touch probe connection);
evaluated only during the probing process
NC NC Not supported
as of
340 422-03,
340 480-03
M 4055 Enable the probing process NC PLC
M 4056 NC stop in all operating modes if stylus is deflected PLC PLC
M 4057 Touch probe cycles active (FN17: ID990 NR2) NC NC 340 422-09,
340 480-09
M 4060 Cycle for tool measurement started NC NC
M 4061 0: Measure the tool
1: Check the tool
NC NC
M 4062 0: Wear tolerance not exceeded
1: Wear tolerance exceeded
NC NC/
PLC
M 4063 0: Breakage tolerance not exceeded
1: Breakage tolerance exceeded
NC NC/
PLC
M 4065 Workpiece dimensions are OK NC PLC
M 4066 Workpiece must be reworked NC PLC
M 4067 Workpiece is scrap NC PLC
Operand Description Set Reset As of SW vers.
Operand Description Set Reset As of SW vers.
M 4070 Strobe signal for gear code NC NC
M 4071 Strobe signal for S code NC NC
M 4072 Strobe signal for M functions NC NC
M 4073 Strobe signal T code (P code) with TOOL CALL NC NC
M 4074 Strobe signal T code (P code) with TOOL DEF NC NC
M 4075 Transfer active with FN19 NC NC
Operand Description Set Reset As of SW vers.
M 4090 Acknowledgment of “gear change completed” PLC PLC
M 4091 Acknowledgment of S code PLC PLC
M 4092 Acknowledgment of M function PLC PLC
M 4093 Acknowledgment of T code (P code) with TOOL CALL PLC PLC
M 4094 Acknowledgment of T code (P code) with TOOL DEF PLC PLC
M 4095 Acknowledgment of transfer with FN19 PLC PLC
Operand Description Set Reset As of SW vers.
M 4120 -
4128
PLC positioning axis 1 to 9 active NC/
PLC
NC/
PLC
M 4130 Activation of spindle orientation, or spindle orientation has been
started with Module 9171
NC/
PLC
NC
M 4131 Activation of Q-parameter transfer to the NC; data from D258, Q
number from W516
PLC NC
M 4132 Activate datum shift from D528 to D544, or call module 9230 PLC NC
M 4133 Starting and stopping the free rotation function PLC NC
M 4134 Activation of a gear range and speed through the PLC PLC NC
M 4135 Strobe marker for selecting the traverse range PLC NC
To Next Page
Loading...
