HEIDENHAIN ITNC 530 - Page 175

July 2010 13 – 175
Adjusting Ethernet
settings on the
control
If you want to adapt the iTNC 530 to your laptop:
8 Write down the IP address and subnet mask of your laptop:
In the prompt enter, e.g. the ipconfig command (or you enter the winipcfg command,
depending on the Windows version).
Now adapt the network settings of the iTNC 530:
With the dual-processor control:
8 Adapt the network settings in Windows:
Start --> Control Panel --> Network Connections --> Local Area Connection --> Properties -->
Internet Protocol (TCP/IP) --> Properties.
Before that write down the original settings.
Note
You can also find this information in My Computer \ Control Panel \ Network ...