26 – 444 HEIDENHAIN Service Manual iTNC 530
The iTNC 530 is currently equipped with the following NC software versions:
Due to restrictions on the export of the iTNC 530, HEIDENHAIN can also supply a special export
version (until now all NC software versions with odd character parity).
HEIDENHAIN releases a new program number for the NC software whenever it introduces
extensive new functions.
PLC software
Preset table
Options
DSP software
Hardware Standard SW Export SW Comment
Single-processor 340 420-xx 340 421-xx without preset tables
340 422-xx 340 423-xx with preset tables
340 490-xx 340 491-xx with preset tables and smarT.NC
programming surface
Dual-processor
(with Windows 2000
or Windows XP)
340 480-xx 340 481-xx with preset tables
340 492-xx 340 493-xx with preset tables and smarT.NC
programming surface
BASIS--51 Random character sequence which the machine manufacturer uses to
identify his PLC software
ON Preset table active
OFF Preset table not active
% Identifier of binary format
0000111100000000 Options enabled in the SIK (e.g. auxiliary axes, tilting
operation, HSC milling etc.)
246261 Program number of DSP software
27 Version of the DSP software
The DSP software designates the operating system for the digital signal processors (DSP)
that are responsible for the speed control of digital axes/spindles:
DSP1: Software for the main controller board
DSP2: Software for the add. controller board
To Next Page
Loading...
