30 – 578 HEIDENHAIN Service Manual iTNC 530
Restoring original
settings
When you have finished error diagnosis or various tests at the machine, you will normally restore
the original settings.
8 Your are in the Machine parameter programming mode.
8 Call the program management.
8 Place the cursor on the original MP list.
8 Load this file into the editor.
8 Press the END key (the iTNC 530 activates the selected original MP file and
performs a reset, if necessary).
Figure: Active MP list in the program manager
In the program management, the active MP file has the entry M in the status column.
To Next Page
Loading...
