30 – 632 HEIDENHAIN Service Manual iTNC 530
MP7500
(is set via the
kinematics
table)
Tilt working plane (active preset table)
Format: %xxxxxxxxx
Input: Bit 0 – “Tilted working plane”
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the tilting axes of the head/table
1: Angles correspond to the spatial angle (the iTNC calculates the position of the tilted
axes of the head/table)
Bit 2 –
0: The tilting axes are not positioned with Cycle 19
1: The tilting axes are positioned with Cycle 19
Bit 3 – No function
Bit 4 – No function
Bit 5 – Test of the tilting axis during "datum setting" in X, Y and Z
0: Current tilting-axis position must fit to the defined tilting angles
1: No test
Bit 6 –
0: Spatial angle C is realized through a rotation of the coordinate system.
1: Spatial angle C is realized through a rotation of the table
Bit 7 – No function
Bit 8 – No function
Bit 9 – Reserved
340 422-01,
340 480-02
PLC
RUN
MP7502 Functionality of M144/M145
Input: %xxx
Bit 0 –
0: M144/M145 not active
1: M144/M145 active
Bit 1 – M144/M145 in the automatic modes
0: M144/M145 active
1: M144 is activated automatically at the start of an NC program. It can only be
deactivated with M145 during an NC program.
Bit 2 – M144/M145 in the manual modes
0: M144/M145 not active
1: M144/M145 active
PLC
RUN
MP7503 Virtual tool axis – Reapproaching the contour and manual traverse in the current tool-axis
direction (FCL2 upgrade function)
Input: 0: Inactive
1: Active
PLC
RUN
MP7506 Selection of kinematics at booting of the control
Input: 0 to 999
-1: Function inactive
340 490-03
MP7507 Selecting the kinematics for the operating mode
Input: %xx
Bit 0
0: Kinematics cannot be selected in Editing operating modes
1: Kinematics can be selected in Editing operating modes for simulation in Test Run
mode
Bit 1
0: Kinematics cannot be selected in Machining operating modes
1: Kinematics of the real machine can be selected in Machining operating modes
340 490-05
MP Function and input SW version
and
behavior
To Next Page
Loading...
