HEIDENHAIN ITNC 530 - Page 7

July 2010 HEIDENHAIN Service Manual iTNC 530
24 Handwheel........................................................................................................................ 399
24.1 Introduction ............................................................................................................... 399
24.2 Possible Causes of Errors.......................................................................................... 400
24.3 Error Location on Portable Handwheel with HR 420 Display .................................... 401
24.4 Error Diagnosis at HR 410 Portable Handwheel........................................................ 406
24.5 Deselecting and Disconnecting the Portable Handwheel ......................................... 409
24.6 Error Diagnosis at Panel-Mounted Handwheels........................................................ 410
24.7 Corrective Action....................................................................................................... 412
25 Touch Probe ..................................................................................................................... 413
25.1 Introduction ............................................................................................................... 413
25.2 Possible Causes of Errors.......................................................................................... 417
25.3 Error Diagnosis on TS Touch Probes......................................................................... 418
25.4 Error Diagnosis on TT Touch Probes ......................................................................... 422
25.5 Error Diagnosis on Laser Touch Probe ...................................................................... 425
25.6 Deselecting and Disconnecting the Touch Probe...................................................... 426
25.7 Corrective Action....................................................................................................... 427
26 Important Features of HEIDENHAIN Components ....................................................... 429
26.1 HEIDENHAIN Components in a Machine Tool .......................................................... 429
26.2 Hardware Identification ............................................................................................. 430
26.3 Display of Important System Information.................................................................. 443
27 Connector Designation and Layout ............................................................................... 447
27.1 Important Note .......................................................................................................... 447
27.2 MC and CC ................................................................................................................ 447
27.2.1 Designation and position of connectors .......................................................... 447
27.2.2 Pin Layouts on the MC and CC ........................................................................ 457
27.3 Power Supply Units................................................................................................... 487
27.3.1 UV 105 power supply unit ............................................................................... 488
27.3.2 UV 105 B power supply unit ............................................................................ 490
27.3.3 UV 106 (B) power supply unit .......................................................................... 492
27.4 Monitors .................................................................................................................... 493
27.4.1 Designation and position of connectors ......................................................... 493
27.4.2 Pin layouts ...................................................................................................... 494
27.5 Keyboard Units .......................................................................................................... 495
27.5.1 Designation and position of connectors .......................................................... 495
27.5.2 Pin layouts ....................................................................................................... 497
27.6 BTS 1x0 Monitor/Keyboard Switch............................................................................ 498
27.7 Machine Operating Panel ....................................................................................... 499
27.7.1 Designation and position of connectors .......................................................... 499
27.7.2 Pin Layouts on MB 420 ................................................................................... 499
27.7.3 Pin layouts on MB 520 ..................................................................................... 500
27.8 Handwheels............................................................................................................... 503
27.8.1 HR 4xx portable handwheel ............................................................................. 503
27.8.2 HR 130 panel-mounted handwheel ................................................................. 504
27.8.3 HRA 110 handwheel adapter ........................................................................... 505
27.9 Touch Probes............................................................................................................. 507
27.10 PLC Input/Output Units ........................................................................................ 507
27.10.1 Designation and position of connectors ........................................................ 507
27.10.2 PL 4xxB Pin Layouts ...................................................................................... 510
27.10.3 Pin layouts for PL 510 .................................................................................... 516
27.11 Encoders.................................................................................................................. 520
27.11.1 Position encoders .......................................................................................... 520
27.11.2 Speed encoders .............................................................................................
522
27.12 Inverters and Mo
tors.............................................................................................. 522
27.13 Interface Boards for the SIMODRIVE System 611D............................................. 522