9 – 96 HEIDENHAIN Service Manual iTNC 530
Calling
DriveDiag
As of NC software version 34049x-04:
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Press the MOD key.
8 Press the DIAGNOSIS soft key.
8 Press the DRIVE DIAGNOSIS soft key.
8 Press the DRIVEDIAG soft key. --> A new window (in addition to the window for
the machine operating modes and the window for the programming modes) is
opened:
Press the MOD key while the program manager is open calls the interface settings.
To Next Page
Loading...
