HEIDENHAIN MANUALPLUS 620 - Page 113

HEIDENHAIN MANUALplus 620 113
2.9 Units—Milling, Face
Cycle form
QK Machining operation
 Roughing
 Finishing
J Milling direction
 0: Unidirectional
 1: Bidirectional
H Mill cutting direction
 0: Up-cut milling
 1: Climb milling
P Maximum approach (maximum infeed)
I Contour-parallel oversize
K Infeed-direction oversize
FZ Approach feed (infeed rate)
E Reduced feed rate
U Overlap factor
Further forms: see page 46